Storix Software SBAdmin User Guide - Manual (Page 26)

From this screen, type the user name in the User name: entry field. When adding a new user you must also
specify the Default Group, User Password, and Select the access level for this user section. Press the
Save button to add the newly configured user.
When finished, press the Cancel button at the bottom.
•
User name – This field indicates the username within the SBAdmin program. This does not
need to be a user defined on the Unix/Linux system.
•
Default Group – This is the group that the user will be logged into when launching the
SBAdmin interface. To allow this user to access other groups, refer to
Groups section.
•
User Password – These fields are for specifying or changing the user password. User
passwords are encrypted and do not need to correspond with system passwords.
•
Select the access level for this user – This selection will determine what functions the user
may perform. For more information, see the
User Levels (Roles) section.
Removing a User
Click Configure !Users from the menu bar. Select the name of the user to remove from the list and press the
Remove button. Any configurations this user may have made will remain intact; however the user will no longer
be able to log into the Administrator.
You must leave at least one user configured with System Admin access.
When finished, press the Cancel button at the bottom.
Changing a User
Click Configure !Users from the menu bar. Select the name of the user to change from the list. Here you may
enter a new password into the User Password: and Re-enter Password fields and or Select the access level
for this user. To change the user press the
Save button.
Storix System Backup Administrator 26 Version 8.2 User Guide