Welch Allyn Acuity and Mobile Acuity LT Central Monitoring Systems - User Manual - Manual (Page 193)

Directions for use Chapter 11 Specifications 189
Virtual Monitor and Waveform Window
Table 32. Virtual Monitor
Features Customizable default Factory default
Virtual Monitor auto open In map view and full screen review view:
•
Upon patient’s monitor connection to Acuity
System if empty window
• Upon alarm if open space is available OR
replaces a non-alarming Virtual Monitor
Patient mode
(listed in patient monitor
Setup status window) Micropaq monitor: adult Propaq LT, CS and Encore monitors: Adult,
pediatric or neonate mode, depending upon
setting at patient monitor
Display settings Acuity System utilizes monitor factory default
settings. For further information, see the monitor
directions for use.
Lead selections Micropaq and Propaq LT monitors:
5-wire cable:
ECG1 LEAD is Lead II
ECG2 LEAD is Lead V
RESP LEAD is Lead III
3-wire cable:
ECG1 LEAD is Lead II
Propaq CS and Propaq Encore monitors:
5-wire cable:
ECG1 LEAD is Lead II
ECG2 LEAD is Lead V
3-wire cable:
ECG1 LEAD is Lead II
Welch Allyn 1500 Patient Monitor:
10-wire cable:
ECG1 LEAD is Lead II
ECG2 LEAD is Lead V
5-wire cable:
ECG1 LEAD is Lead II
ECG2 LEAD is Lead V
3-wire cable:
ECG1 LEAD is Lead II
Number of waveforms
displayed simultaneously Up to three
Display priority of
waveforms All waveforms on (ECG always displayed if
monitored):
1. ECG 1
5. P2 9. RESP
2. ECG 2 6. P3 10. SpO
2
3. ECG 3 7. P4 11. NIBP
4. P1 8. CO
2
Number of vital sign
numerics displayed
simultaneously Eight (if six or more are monitored at once,
Temperature and NIBP values alternate in the
same space)
If CO
2
is active and turned on at the patient
monitor, BR numerics are shown; second choice
is RR numerics, when impedance pneumography
is active