Welch Allyn Acuity and Mobile Acuity LT Central Monitoring Systems - User Manual - Manual (Page 172)

168 Chapter 10 Troubleshooting and maintenance Welch Allyn Acuity Central Monitoring System
Identify or change a Wireless Propaq CS network name
To identify a wireless Propaq CS monitor network name and prepare to change it (if
desired)
1. Touch , SETUP, MORE, MORE, SERVICE, YES, MORE, MORE, RADIO.
The Network Status screen opens, and the NET NAME is listed.
2. Take one of these steps:
• If you want to change the network name, continue below to “To proceed to
change a wireless Propaq CS monitor network name”.
• If you do not want to change the network name, touch to return to the
main menu.
To proceed to change a wireless Propaq CS monitor network name
1. Touch CHANGE NET NAME.
The Change Net Name screen appears.
2. Touch NEXT repeatedly until the new network name is highlighted.
3. Carefully confirm that the highlighted name matches the appropriate Acuity System
network name.
4. Touch SELECT.
An ARE YOU SURE? confirmation screen appears.
5. Respond to the confirmation prompt.
If you touch YES, the Propaq CS monitor turns off and on again, and then it attempts
to connect to the Acuity System network.