Welch Allyn Acuity and Mobile Acuity LT Central Monitoring Systems - User Manual - Manual (Page 171)

Directions for use Chapter 10 Troubleshooting and maintenance 167
Identify or change a Propaq LT monitor network name
To identify a Propaq LT monitor network name and prepare to change it (if desired)
1. Highlight SpO2, and then press .
2. Highlight Setup, and then press .
The Setup menu appears.
3. Highlight Service, and then press .
The Service menu appears.
4. Highlight Radio, and then press .
The Radio menu appears, and Show Info is highlighted
5. Take one of these steps:
• If you want to change the network name: Continue below to “To proceed to change a
Propaq LT monitor network name”.
• If you do not want to change the network name:
a. Press .
The current network name is shown.
b. Highlight Exit, and then press .
You have completed the network name identification process.
To proceed to change a Propaq LT monitor network name
1. Highlight NetName and press .
2. Highlight the new network name.
3. Carefully confirm that the highlighted name matches the appropriate Acuity System
network name.
4. Simultaneously press and , and hold for one second.
The Propaq LT monitor turns off and on again, and then it attempts to connect to the
Acuity System network.