Elecraft K3 Assembly Manual - Manual (Page 7)

6
We strongly recommend you take the following anti-static precautions (listed in order of importance) to avoid
trouble:
 Leave ESD-sensitive parts in their anti-static packaging until you install them. The packaging may be a
special plastic bag or the component’s leads may be inserted in conductive foam. Parts which are
especially ESD-sensitive are identified in the parts list and in the assembly procedures.
 Wear a conductive wrist strap with a series 1-megohm resistor. If you do not have a wrist strap, touch a
ground briefly before touching any sensitive parts to discharge your body. Do this frequently while you
are working. You can collect a destructive static charge on your body just sitting at the work bench. DO
NOT attach a ground directly to yourself as this poses a serious shock hazard.
 Use a grounded anti-static mat on your work bench.
 If you choose to use a soldering iron to work on your K3 for any reason, be sure the iron is ESD-safe
with a grounded tip tied to the same common ground used by your mat or wrist strap.
Preparing for Assembly
Overview of the Kit
The kit comprises two major assemblies: the main chassis and the front panel. Figure 1 shows an assembled
K3/10 with its top cover removed.
The main chassis is literally built up around the RF circuit board, which fills the entire bottom of the unit of the
chassis assembly. Panels are mounted around the RF board using Elecraft’s 2D fasteners. These fasteners allow
individual removal of any one panel, if needed, to gain access to the inside of the radio for servicing. Very few
cables or wires are used in the kit. Most of the other boards and optional accessories plug directly into the RF
board or one of the boards mounted on the RF board.
The front panel assembly, including the display and main operator controls, includes the front panel board and
the digital signal processing (DSP) board.
There are many options that you can add to the basic K3/10, such as the 100 watt amplifier module, internal
antenna tuner, second receiver, additional crystal I.F. filters, etc. If you purchased these options with your K3
kit, you will find instructions to install them at proper places in the assembly procedure to make getting your
complete K3 together and operational in the most efficient manner.