Dell Compellent Series 30 - Manual (Page 183)

175
Creating a Remote Storage Center Connection
Note NAT is not available to systems using Virtual Ports, so if either the local or remote
systems is using Virtual Ports, NAT is not enabled.
• If NAT is Enabled, go to .
• If NAT is not enabled, continue with .
3 If NAT is enabled:
a Click Yes NAT.
b Enter the NATed IP addresses and iSCSI Names for the remote Compellent iSCSI
cards.
c Click Continue. The link speed window appears. Continue with Step 5 on page 175.
4 Click No NAT. The IP Addresses window appears.
Figure 143. Add iSCSI Remote Compellent Connections
5 Add the remote addresses:
• If the remote system is using iSCSI Virtual Ports, add the IP addresses of the
Control Port.
• If the remote Storage Center system is not using iSCSI Virtual Ports, add the IP
addresses of each IO Card.
6 Click Continue. The link speed window appears.
7 Enter the speed of the network link between this system and the remote Storage Center.
system: T1, T3/100 MB, Gigabit, or greater.
8 Click Continue or Advanced.
a If you click Advanced, the Advanced Options window appears.