Dell PowerEdge C6220 II - Manual (Page 121)

Using the System Setup Program | 121
Token Setup option Description
00D8 Load Optimal
Defaults Requests a optimal default of SETUP values on the next
boot.
00FE Legacy USB
Support System does not provide legacy USB support for operating
system.
00FF Legacy USB
Support
System provides legacy USB support for operating system.
0117 SATA Port0 Sets the 1st Serial ATA drive controller to OFF.
0118 SATA Port0 Sets the 1st Serial ATA drive controller to Auto (enabled if
present, POST error if not present).
0119 SATA Port1 Sets the 2nd Serial ATA drive controller to OFF.
011A SATA Port1 Sets the 2nd Serial ATA drive controller to Auto (enabled
if present, POST error if not present).
011B SATA Port2 Sets the 3rd Serial ATA drive controller to OFF.
011C SATA Port2 Sets the 3rd Serial ATA drive controller to Auto (enabled if
present, POST error if not present).
011D SATA Port3 Sets the 4th Serial ATA drive controller to OFF.
011E SATA Port3 Sets the 4th Serial ATA drive controller to Auto (enabled
if present, POST error if not present).
011F SATA Port4 Sets the 5th Serial ATA drive controller to OFF.
0120 SATA Port4 Sets the 5th Serial ATA drive controller to Auto (enabled
if present, POST error if not present).
0121 SATA Port5 Sets the 6th Serial ATA drive controller to OFF.
0122 SATA Port5 Sets the 6th Serial ATA drive controller to Auto (enabled
if present, POST error if not present).
0135
Embedded
SATA Controller
Disables the SATA controller. The token applies to the
first on-board SATA controller.
0137 Embedded
SATA Controller Enables the SATA controller. Sets the device class code as
IDE and uses PCI IRQ (referred as Native mode). This
token applies to the first on-board SATA controller.
0138 Embedded
SATA Controller Enables the SATA controller. Sets the device class code as
SATA and sets up the AHCI BARs and registers. This
token applies to the first on-board SATA controller.