Yamaha LS9 - Manual (Page 74)

74
Sending signals from MIX channels to the STEREO/MONO bus
LS9-16/32 Owner’s Manual
If the CSR knob is set to 100%, operating the TO ST
PAN knob will change the signal levels sent to the
STEREO (L/R) bus and MONO (C) bus as shown in
the following illustration.
If a stereo MIX channel is selected, operating the TO
ST BALANCE knob will change the signal levels sent
from the MIX channel to the STEREO (L/R) bus and
MONO (C) bus as shown in the following illustration.
14
If you want to operate a channel that is not
currently shown in the popup window, use
the [SEL] key to select that channel, and
then make settings for it.
For example if MIX channels 1–8 are shown in the
popup window, pressing the MIX channel 9 [SEL] key
will change the popup window to MIX channels 9–16.
15
When you’ve finished making settings,
move the cursor to the CLOSE button (or
the
× symbol in the upper right of the win-
dow) and press the [ENTER] key.
C L R
PAN knob
Signal sent to the
MONO (C) bus
Signal sent to the
STEREO (L) bus
Signal sent to the
STEREO (R) bus
Signal le
vel
C L R
TO ST BALANCE knob
Signal sent from the
odd-numbered MIX
channel to the STE-
REO (L) bus
Signal sent from the
odd-numbered MIX
channel to the
MONO (C) bus
C L R
TO ST BALANCE knob
Signal sent from the
even-numbered MIX
channel to the
MONO (C) bus
Signal sent from the
even-numbered MIX
channel to the STE-
REO (R) bus
Signal le
vel
Signal le
vel