Using dynamics, P. 117) – Yamaha LS9 User Manual
Page 117
117
11
EQ and Dynamics
LS9-16/32 Owner’s Manual
6
If you want to use the high-pass filter on an
input channel, operate the HPF FREQ knob
or HPF ON/OFF button in the ATT/HPF/EQ
popup window.
Input channels provide a high-pass filter that is inde-
pendent of the four-band EQ. Use the HPF ON/OFF
button to switch the high-pass filter on/off, and use the
HPF FREQ knob to specify the cutoff frequency.
7
If you want to initialize EQ settings or copy
them to another channel, use the tool but-
tons in the ATT/HPF/EQ popup window.
For details on how to use these buttons, refer to “Using
the tool buttons” (
Input channels provide two dynamics processors, and output channels provide one dynamics
processor.
1
Press the SELECTED CHANNEL section
[HOME] key.
The SELECTED CH VIEW screen will appear in the
display.
1
DYNA1 popup button
B
DYNA2 popup button (input channels only)
2
Use the LAYER section to select the desired
fader layer.
3
Press a [SEL] key in the channel module
section, STEREO MASTER section, or ST IN
section to select the channel that you want
to operate.
4
In the screen, move the cursor to the
DYNA1/DYNA2 popup button or any knob in
the DYNA1/DYNA2 field, and press the
[ENTER] key.
The DYNAMICS 1/DYNAMICS 2 popup window
will appear. In this popup window you can view and
edit all dynamics parameters of the currently selected
channel.
• Output channels do not provide a high-pass filter that is inde-
pendent of the EQ. However by turning on the high-pass filter
button in the popup window, you can use the LOW band EQ
as a high-pass filter.
• For both input channels and output channels, you can turn on
the low-pass filter button and use the HIGH band EQ as a
low-pass filter.
HINT
• You can also use a dedicated library to save or load EQ set-
tings at any time (
→ p. 120). You can also take advantage of a
wide variety of presets suitable for various instruments or situ-
ations.
• You can also use the encoders of the SELECTED CHANNEL
section to adjust the EQ or high-pass filter (
HINT
Using dynamics
1
2
• If you’ve turned on POPUP APPEARS WHEN PRESSING
KNOBS in the PREFERENCE popup window (
can also access the above popup window by pressing any of
the [DYNAMICS 1]/[DYNAMICS 2] encoders while the
SELECTED CH VIEW screen is shown.
HINT