Yamaha LS9 - Manual (Page 222)

222
Initializing the LS9’s internal memory
LS9-16/32 Owner’s Manual
If an error occurs in the LS9’s internal memory, or if you have forgotten the password, you can
use the following procedure to initialize the internal memory.
1
While holding down the [SCENE MEMORY]
key of the DISPLAY ACCESS section, turn
on the power.
After the opening screen, the following startup menu
screen will appear.
1 MODE SELECT field
B INITIALIZE ALL MEMORIES button
C INITIALIZE CURRENT MEMORIES button
2
According to the desired type of initializa-
tion, move the cursor to one of the buttons
in the MODE SELECT field, and press the
[ENTER] key.
● INITIALIZE ALL MEMORIES button
The entire memory including scene memories and
libraries will be returned to their factory-set condition.
● INITIALIZE CURRENT MEMORIES button
The contents of memory except for scene memories
and libraries will be returned to its factory-set condi-
tion.
3
To execute the Initialize operation, move the
cursor to the INITIALIZE button located in
the dialog box at the left side of the screen,
and press the [ENTER] key.
A dialog box will ask you to confirm the operation.
4
Move the cursor to the OK button of the
dialog box and press the [ENTER] key.
Initialization will begin.
5
When initialization has been completed,
move the cursor to the EXIT button and
press the [ENTER] key.
The console will start up in normal operating mode.
Initializing the LS9’s internal memory
• The entire contents of memory will be lost if you initialize the internal memory. Proceed with the following
operation only if you are very sure you want to do this.
CAUTION
1
3
2
• Do not press any key until initialization has been completed.
NOTE
• If the backup battery voltage is low, or if an error occurs in the
internal memory, a warning dialog box will appear, and then
the initialization menu will appear. If the warning dialog box
appears, and you select the EXIT button to start up in normal
operating mode, Yamaha cannot guarantee that the unit will
operate correctly.
NOTE
• Instead of using the EXIT button, you can also select a differ-
ent button of the MODE SELECT field.
HINT