Yamaha LS9 User Manual
Page 104
104
Directly outputting an INPUT channel
LS9-16/32 Owner’s Manual
4
Move the cursor to the port select popup
button, and press the [ENTER] key.
The OUTPUT PORT SELECT popup window will
appear, allowing you to select the output port that will
be patched to direct output.
1
Category tab
These tabs select the output ports that are shown in the
popup window. Each tab corresponds to the following
output ports.
●
OMNI / 2TR OUT
Shows OMNI OUT jacks 1–8 {1–16} and 2TR
OUT DIGITAL jack.
●
SLOT {1/2}
Shows output channels 1–16 of the slot(s) {1/2}.
●
REC IN
Shows USB memory recorder input channels.
B
Port select button
This selects the output port that is assigned to direct
output.
5
Use the category tabs and the port select
buttons to select the port that will be the
direct output.
6
Move the cursor to the CLOSE button and
press the [ENTER] key to return to the pre-
vious screen.
7
Move the cursor to the direct out point
select box, and use the dial or the [DEC]/
[INC] keys to select the direct out point.
You can choose PRE HPF (immediately before the
high-pass filter), PRE EQ (immediately before the
EQ), or PRE FADER (immediately before the fader).
8
Move the cursor to the DIRECT OUT ON/
OFF button, and press the [DEC]/[INC] keys
or the [ENTER] key to turn it ON.
This enables the direct output you specified.
9
As necessary, move the cursor to the
DIRECT OUT LEVEL knob and use the dial
or the [DEC]/[INC] keys to adjust the level of
the direct output.
LS9-16
1
2
• As an alternate method of specifying a direct output, you can
select an INPUT channel as the output source of an output
port (
HINT