Yamaha LS9 User Manual
Page 52
52
Setup required when starting up
LS9-16/32 Owner’s Manual
4
In the STEREO MASTER section of the top
panel, make sure that the STEREO channel
[ON] key is on, and raise the STEREO chan-
nel fader to 0 dB.
5
Make sure that the ST button for each chan-
nel in the window is on (white characters on
a pink background).
The ST button is an on/off switch for the signal sent
from each channel to the STEREO bus. This is the
same function as the ST button in the SELECTED CH
VIEW screen.
6
To adjust the pan (INPUT channel) or bal-
ance (ST IN channel) of the signal sent from
the input channel to the STEREO bus, move
the cursor to the PAN/BAL knob of the
desired channel in the window, and operate
the dial or the [DEC]/[INC] keys.
7
In the channel module section or the ST IN
section, make sure that the [ON] key of the
channel you want to operate is turned on.
8
Raise the fader/encoder of each channel to
obtain an appropriate volume.
9
If you want to operate a channel that is not
currently shown in the popup window, use
the [SEL] key to select that channel, and
then make settings for it.
For example if INPUT channels 1–8 are shown in the
popup window, pressing the INPUT channel 9 [SEL]
key will change the popup window to INPUT channels
9–16. If you press a [SEL] key of the ST IN section,
the L/R channels of ST IN channels 1–4 will be dis-
played together.
• If you’ve turned on POPUP APPEARS WHEN PRESSING
KNOBS in the PREFERENCE popup window (
can also access this popup window by pressing the
SELECTED CHANNEL section [PAN] encoder.
HINT