Yamaha LS9 User Manual

Page 61

Sending the signal from an input channel to the STEREO/MONO bus

Input channel oper

ations

LS9-16/32 Owner’s Manual

If a ST IN channel is selected, operating the TO ST
BALANCE knob will change the signal levels sent
from the ST IN L/R channels to the STEREO (L/R)
bus and MONO (C) bus as shown in the following
illustration. In this case, the [PAN] encoder will oper-
ate as a conventional BALANCE knob, and no signal
is sent to the MONO (C) bus.

If the CSR knob is set to 100%, operating the TO ST
PAN knob will change the signal levels sent to the
STEREO (L/R) bus and MONO (C) bus as shown in
the following illustration.

If you want to operate a channel that is not
currently shown in the popup window, use
the [SEL] key to select that channel, and
then make settings for it.

For example if INPUT channels 1–8 are shown in the
popup window, pressing the INPUT channel 9 [SEL]
key will change the popup window to INPUT channels
9–16.

When you’ve finished making settings,
move the cursor to the CLOSE button (or
the

× symbol in the upper right of the win-

dow) and press the [ENTER] key.

TO ST PAN knob

Signal sent to the
STEREO (L) bus

Signal sent to the
STEREO (R) bus

Signal le

vel

TO ST BALANCE knob

Signal sent from the
ST IN (L) channel to
the STEREO (L) bus

TO ST BALANCE knob

Signal sent from the
ST IN (R) channel to
the STEREO (R) bus

Signal le

vel

Signal le

vel

PAN knob

Signal sent to the
MONO (C) bus

Signal sent to the
STEREO (L) bus

Signal sent to the
STEREO (R) bus

Signal le

vel

TO ST BALANCE knob

Signal sent from the
ST IN (L) channel to
the STEREO (L) bus

Signal sent from the
ST IN (L) channel to
the MONO (C) bus

TO ST BALANCE knob

Signal sent from the
ST IN (R) channel to
the STEREO (R) bus

Signal sent from the
ST IN (R) channel to
the MONO (C) bus

Signal le

vel

Signal le

vel