Yamaha LS9 - Manual (Page 269)

Warning/Error Messages
269
LS9-16/32 Owner’s Manual
Appendices
SLOT x: Data Framing Error! Invalid signals are being input from the SLOT x input port.
SLOT x: Data Overrun! Invalid signals are being input from the SLOT x input port.
SLOT x: Rx Buffer Full! Too much data is being received at the SLOT x input port.
SLOT x: Tx Buffer Full! Too much data is being sent from the SLOT x output port.
Some Song Files Are Unidentified.
There was a song file that could not be identified. It is possible that the song being used for DIRECT
PLAY or SCENE PLAY BACK LINK is different than the song that was specified.
Song File Not Found! The file assigned to SCENE LINK or to the DIRECT PLAY user defined key does not exist.
Storage Full! The file could not be saved because there is not enough space on the USB memory.
Storage Not Found! The USB memory could not be recognized.
Storage Not Ready! Access is not possible because the USB memory is not ready.
Sync Error! [xxx] The LS9 is not synchronized with the [xxx] signal.
Tap Operation Ignored. Tap operation was ignored because the TAP TEMPO button is not displayed in the screen.
This Operation is Not Allowed. This operation has been ignored because the current user does not have permission.
Too Large Files! Loading Failed.
Loading is not possible because the bitmap file is too large. The maximum supported file size is
307,256 bytes.
Too Many Bands Used! Cannot Compare. More than 15 bands are used, when trying to copy 31band GEQ and then compare with Flex15GEQ.
Too Many EQ Bands Used! Cannot Paste! More than 15 bands are used, when trying to copy 31band GEQ and then paste to Flex15GEQ.
Total Slot Power Capability Exceeded! The I/O cards installed in the slots exceed the rated power capacity.
Unsupported File Format! The file you attempted to load from the USB memory is of an unsupported format.
USB: Data Framing Error! Invalid signals are being input from the USB connector input port.
USB: Data Overrun! Invalid signals are being input from the USB connector input port.
USB: Rx Buffer Full! Too much data is being received at the USB connector input port.
USB: Tx Buffer Full! Too much data is being transmitted from the USB connector output port.
USB Currently Active for Recorder
function! Since the USB memory recorder is recording or playing back, functions such as Save/Load cannot be
used.
USB Currently Active for SAVE or LOAD!
The recorder cannot oparate, since mixer scene memory/library data is being saved or loaded in USB
memory.
USB Memory Busy: Recorder Stopped! Recording/playback stopped because time is required for USB memory processing.
USB Memory Full! Recorder Stopped.
Recorder processing was halted because the USB memory capacity ran out while the USB memory
recorder was operating.
USB Memory Unmounted! Recorder
Stopped. Recorder processing was halted because the USB memory was disconnected while the USB memory
recorder was operating.
USB over current Error! Disconnect USB
device. Excessive current has occurred at the USB connector.
Disconnect the USB memory that is connected to the USB connector.
Word Clock Error! Recorder Stopped! Recorder was halted because synchronization with the word clock was lost.
Wrong Audio File Format! The format of the audio file is invalid.
Wrong Password! The password you input was incorrect.
Wrong Word Clock!
The LS9 cannot synchronize because the source selected by MASTER CLOCK SELECT in the WORD
CLOCK screen is not appropriate.
You Cannot Create User Key. The current user does not have permission to create a user key.
Message Meaning