Metrohm 766 IC Sample Processor - Manual (Page 64)

4.3 Methods
766 IC Sample Processor
59
parameters
>start sequence Start sequence of a sample series
The processing sequence entered here is executed once at
the start of a sample series. This can be useful for switching
on external devices, for example.
In this submenu up to 99 command lines can be entered as a
processing sequence (see section 4.3.3).
parameters
>sample sequence Processing sequence for each sample
This processing sequence is executed during the proc-
essing of every sample of a series.
In this submenu up to 99 command lines can be entered as a
processing sequence (see section 4.3.3).
parameters
>final sequence Final sequence of a sample series
This processing sequence is executed once at the end of a
sample series. This could be the useful for switching off ex-
ternal devices, for example.
In this submenu up to 99 command lines can be entered as a
processing sequence (see section 4.3.3).
parameters
>changer settings Settings for 766 IC Sample Processor
>changer settings
rack number 2
0 … 16
Rack that is assigned to the method
0
= no particular rack
This setting can force the use of a certain rack with the
method chosen. If this is not desired, the rack number
'0' must be chosen.
>changer settings
lift rate 1 12 mm/s
3 … 12 mm/s
Stroke speed of lift
>changer settings
shift rate 20
3 … 20
Rack shift rate
Turning speed of the rack in angular degrees/second