Metrohm 766 IC Sample Processor - Manual (Page 130)

6.5 Initialize data memory
766 IC Sample Processor
125
• Prepare instrument for diagnostic test (see section 6.4.2).
• If need be, press <9> key repeatedly until
diagnosis
>RAM initialization
• Press key to open the following diagnostic menu:
>RAM initialization
select: param
ü
>RAM initialization
select: config
ü
>RAM initialization
select: setup
ü
>RAM initialization
select: assembly
ü
>RAM initialization
select: all
ь ь ь ь ь
Set method parameters with default values. Ã
Set config parameters with default values. Ã
Set setup parameters with default values. Ã
Set assembly parameters with default values. Ã
Deletes all user-defined methods Ã
• Pressing the key selects the submenus in turn. The in-dividual initialization alternatives are accessed using the key, exit is with the key.• The table shows which parts of the data memory are affected by thecorresponding initialization alternatives. When the instrument reactswith a system crash after being switched on (undefined display, noreactions to keystroke, etc.) we recommend to carry out the initiali-zation with the submenu 'all'.• If need be, press the key repeatedly until:
dividual initialization alternatives are accessed using the
key, exit is with the key.
• The table shows which parts of the data memory are affected by the
corresponding initialization alternatives. When the instrument reacts
with a system crash after being switched on (undefined display, no
reactions to keystroke, etc.) we recommend to carry out the initiali-
zation with the submenu
'all'
.
• If need be, press the
>RAM initialization
select: all
• Press .
diagnosis
>RAM test
• Press .
The instrument quits the diagnostic menu and runs a power on reset.