Metrohm 766 IC Sample Processor - Manual (Page 32)

3.1 Prerequisites / Preparations
766 IC Sample Processor
27
3 Operating tutorial
In order to become acquainted with the 766 IC Sample Processor and its
mode of operation, it is helpful to work through the short Operating
Tutorial. The basic operating steps that are required to prepare the first
sample series and run it with a given method are described here.
For further explanations of the operation, please refer to section 4, which
describes the functions of the individual keys and the programming in
detail.
3.1 Prerequisites / Preparations
• It is assumed that the 766 IC Sample Processor is fully installed (see
section 2). Don’t forget to mount the splash protection and the plug
cover.
• Connect a 732 IC Detector at the remote connection 22 22 (see section
2.4).
• Choose a simple IC method that you have saved in the 732 IC De-
tector or create a new simple method.
• The <é> and <ê> keys can be used to move the lift up or down.
RESET
CLEAR *
>
ENDSEQ
• Install the 6.2041.430 sample rack. Press or
+ . The 766 IC Sample Processor is initial-
ized in this way with the lift and rack placed in the rest position. In
this position the magnetic rack code can be read so that the inter-
nally stored rack data (position table, etc.) can be loaded.
This should be done after every rack change.
• Insert some sample tubes into the sample rack, beginning with
position 1. Using the keys <ç> and <è> the rack can be turned
for this purpose.