Metrohm 766 IC Sample Processor - Manual (Page 49)

4 Operation
766 IC Sample Processor
44
Key Normal state Edit mode
• "<" serves also for shifting the
chain of characters to chose from,
i.e. the text cursor is shifted one
place to the left for each instance
(see section 4.1.6).
*
>
ENDSEQ Initialization
• The 766 IC Sample Processor is
initialized with the key
followed by .
• A method in the working memory
remains unchanged. The rack and
the lift are run to the initial position.
Text entry
• In a menu or sequence line in
which entry of text is required, (e.g.
method name), text edit mode is
activated with ">". Existing text
remains in this event and the text
cursor is set at the end of the ex-
isting character string.
• ">" serves also for shifting the
chain of characters to chose from,
i.e. the text cursor is shifted one
place to the right for each instance
(see section 4.1.6).
Set end mark
• For test purposes an
command can be placed at any
line desired in a sequence. This
has the effect that the sequence is
only executed up to this end mark.
START
Start a method
• The key starts a
method. Starting is only possible
when the IC Sample Processor is in
the normal state, i.e. when 'ready'
is shown in the display.
• When starting a sample series, the
sample counter is set to 0.
• When is pressed after
an interruption (), the
sequence is continued with the next
command line.
Trace function
• During editing of a sequence, the
command defined in the command
line can be directly executed with
the key.
• A sequence can therefore be tested
from start to finish (or in parts) in
single steps ("tracing").