beautypg.com

Rockwell Automation 1772-LP3 PLC - 2/30 Programmable Controller Programming and Operations Manual User Manual

Page 170

background image

Report Generation

Chapter 9

9Ć2

Real-time calendar – you can enter and display the date, and use the date

in a message. Date format is month/day/year — July 16, 1984 is
7/16/84.

Peripheral fault detection – module sets bit 027/06 in the processor data

table when the module detects a fault in the peripheral device

Module reconfiguration – you can reconfigure the module’s operational

configuration (internal switch settings) from the peripheral device
keyboard

Selectable communications configuration – you can select EIA

RS-232C communication (up to 50 feet) or A-B long line
communication (up to 5,000 feet) with the RG module

Selectable communication rates – allow you to increase the

communication rate to 19,200 bits

Selectable number of data bits – you can choose either seven or eight

data bits per character

Messages can be entered into memory from either the T3 industrial
terminal or a peripheral device connected to channel C of the industrial
terminal. If the industrial terminal is used, one of two keytop overlays can
be used, depending on whether graphic characters are desired (Figure 9.1):

Alphanumeric Keytop Overlay (Cat. No. 1770-KAA)

Alphanumeric/Graphics Keytop Overlay (Cat. No. 1770-KAB)

The messages can be manually displayed or printed on the T3 industrial
terminal or peripheral device by a key sequence each time a message
is desired. They can also be activated through program control by
programming specific data table bits in the ladder diagram program
(Section 9.3).