beautypg.com

1772-6.8.3, 9 - report generation, Report generation – Rockwell Automation 1772-LP3 PLC - 2/30 Programmable Controller Programming and Operations Manual User Manual

Page 169

background image

9

Chapter

9Ć1

Report Generation

The report generation function of the T3 industrial terminal, performed in
the PLC-2 mode, can be used to generate messages that contain ASCII and
graphic characters, and variable data table information. The messages are
stored in the processor’s memory after the END of program statement.

We also have a PLC-2 Family Report Generation Module (Cat. No.
1770-RG) which performs the report generation function. This feature
is used to generate messages stored in the processor’s memory. These
messages may be generated manually or automatically.

The T3 industrial terminal and the RG module features include:

Up to 70 messages – you can choose the number of messages to be

stored

Simple programming – only 2 or 3 rungs of programming are required

to display a message by program logic

Intelligent printer interface – the RG module can monitor a busy/ready

signal from the printer

Selectable communication rates – you can choose from seven

communication rates: 110, 300, 600, 1200, 2400, 4800 or 9600 bits per
second

Selectable parity bit – you can choose odd, even or no parity

In addition to these features, the RG module features include:

Stored messages – Up to 198 messages can be stored

On-Line message store, edit or delete – you can store, edit or delete a

message while the processor is executing its program

Message protection – module guards against inadvertent deletion of a

message

Real-time clock – you can enter and display the time, and use the time

in a message. Time format is the 24-hour (military) format — 4:15 PM
is 16:15 hours

9.0
General