Rockwell Automation 20-COMM-E PowerFlex EtherNet/IP Adapter - Manual (Page 15)

20-COMM-E EtherNet/IP Adapter User Manual
Publication 20COMM-UM010G-EN-P
Chapter 1
Getting Started
The adapter is intended for installation in a PowerFlex 7-Class drive and is
used for network communication. The 20-COMM-E Series B adapter,
firmware 3.xxx or later, can also be installed in an External DPI Comms Kit
(20-XCOMM-DC-BASE).
For PowerFlex 750-Series drives, we recommend using the 20-750-ENETR
Dual-port EtherNet/IP option module or the embedded EtherNet/IP adapter
(only in PowerFlex 755 drives) instead of the 20-COMM-E adapter.
However, this manual does include information about using the
20-COMM-E adapter with PowerFlex 750-Series drives—but there are
operating limitations. For details, see
Compatible Products on page 1-3 .
Components
Topic Page
Components 1-1
Features 1-2
Compatible Products 1-3
Required Equipment 1-3
Safety Precautions 1-5
Quick Start 1-6
Item Part Description
➊ Status Indicators Four status indicators that indicate the status of the DPI, the
adapter, and network connection. See Chapter 7 , Troubleshooting .
➋ DPI Connector A 20-pin, single-row shrouded male header. An Internal Interface
cable is connected to this connector and a connector on the drive.
➌ Ethernet Connector RJ-45 connector for the Ethernet network cable. The connector is
CAT-5 compliant to ensure reliable data transfer on 100Base-TX
Ethernet connections.
➍ Web Pages Switch
(SW2)
Enables or disables the adapter web pages. See Setting the Web
Pages Switch (only Series B Adapter, Firmware 3.xxx or Later) on
page 2-2 . SW1 is unused.
➊
➋
➌ ➍ Not provided on Series A adapter