RKI Instruments GX-2012 Manual - Manual (Page 59)

GX-2012 Operator’s Manual Display Mode • 51
User ID Screen
This screen displays only if ID DISP in the Maintenance Mode menu is set to
ON (see “Turning the ID Display Function On or Off” on page 135). Each
user ID can contain up to 16 characters but only the first 8 of those characters
are visible in the instrument. Be sure that all user IDs are distinguishable
from each other by viewing only the first 8 characters. For more information,
see the GX-2012 Data Logger Management Program manual. The bottom
line of the screen alternates between YES/ENT., the current user ID, and NO
/DISP. Uppercase letters, numbers, asterisks (*), dashes (-), and a blank space
are available characters. The GX-2012 can store 128 user IDs.
Use this screen to identify or change the user. The user ID provides a way to
identify the user during a data logging session. The user ID is saved to the
data logger for that session when you turn off the
GX-2012 or change users during operation. This allows you to change the
user ID during operation and have each user ID that was used during an
operating session saved for the corresponding data.
NOTE: As shipped from the factory, the user ID on this screen is shown as -
- -- -- -- -- -- until you enter this screen and select a user ID.
To change a user:
1. After entering Display Mode and proceeding to the User ID screen, press
and release the POWER ENTER button. The bottom line of this screen
alternates between YES/ENT., the current user ID, and NO /DISP.
U Id
YES/ENT.
SEL
U Id
USER--001
SEL