RKI Instruments GX-2012 Manual - Manual (Page 105)

GX-2012 Operator’s Manual Leak Testing • 97
Viewing Snap Log Data in Leak Check Mode Operation
Snap log data can be viewed while in Leak Check Mode. If snap log data was
taken while in Normal Operation, that data will also appear.
1. Turn the GX-2012 on as described in “Turning On the GX-2012, Leak
Check Mode” on page 84.
2. Press and hold the RESET SILENCE button and then press and hold the
DISPLAY (ADJ) button and release both.
3. If no snap logs have been performed, the following screen will appear.
Press and release the DISPLAY (ADJ) button to return to Leak Check
Mode.
4. If snap logs have been performed in either Normal Operation or Leak
Check Mode Operation, one of the following screens will appear. LEAK
CK MODE will appear in the upper left corner of Leak Check Mode
Operation data to indicate that the snap log was taken during Leak Check
Mode Operation.
This screen indicates the year, month, day, and time that the most recent
snap log was taken. The number along the bottom of the screen indicates
the snap log ID number. The first snap log that is taken is given an ID of
M001. The next snap log ID is M002. The ID number increases
sequentially with each set of snap log data. Use the AIRS and (SHIFT)T
buttons to scroll through different snap log IDs and view what time and
day they were taken. Snap log data that was taken in Leak Check Mode
NO DATA
2012
2
15
14:17
LEAK CK MODE
M009
2011
8
31
22:39
M023
Normal Operation Leak Check Mode Operation
Snap Log Snap Log