ETC Ion - Manual (Page 87)

4
Patch 71
Editing a copy of a scroll or wheel
If a copy has been made of an existing scroll or wheel, the copied scroll or wheel will display as
{New Wheel n} before the standard manufacturer offerings. The frame list will include an exact
duplicate of the copied selection.
To make a change to a frame, first select the frame then press {Edit} to display the media selection.
Or you can insert a new frame above a selected frame using the {Insert} softkey.
For example, to insert a new frame in between existing frames 2 and 3, select frame 3 and press
the {Insert} key. The media selection will display.
When a manufacturer is selected from the list, the catalog selection changes to display only the
selected manufacturer’s offerings. When a specific catalog is selected, the media will display in the
last three columns of the editor.
When you make a media selection, the display returns to the new wheel frame list where additional
frames can be edited in the scroll or wheel.
Scroller Fan Curves
Curves can be applied to the scroller fan parameter allowing for the output of the fan to be
controlled by the intensity of the channel. The curves available for this are the same used for
intensity parameters and cues.
See “Storing and Using Curves” on page 277.
To set a curve to a scroller fan, go to Displays>Patch>Attributes>Fan Curve for each scroller.
The media selection includes the following
softkeys:
• {Gel}, {Color}, {Gobo}, and {Effect} - each will
display available media selections as they are
cataloged by the associated scroll or wheel
manufacturers.
• {Open Frame} - places the frame in Open
White.
• {Cancel} - cancels the media selection and
returns to the frame editor.
Manufacturer
List
Manufacturer
catalog
Cataloged media