ETC Ion - Manual (Page 177)

10
Using Fan 161
Fanning References
When fanning references, such as palettes, if there are more that 2 reference lists are used then the
data will be referenced data. The fan will be repeated if there are more channels than references.
• [1] [Thru] [5] [Int Palette] [1] [Thru] [3] [Enter] - sets channel 1 to IP1, 2 to IP2, 3 to IP3, 4
to IP1, and 5 to IP2.
If the list contains 2 or less references, fan will be set to the levels between the references as
absolute data.
• [1] [Thru] [5] [Int Palette] [1] [Thru] [2] [Enter] - (Intensity palette 1 is all channels at 0% and
Intensity palette 2 is all channels set to 100%.) sets channel 1 to 0%, 2 to 25%, 3 to 50%, 4
to 75%, and 5 to 100% as absolute data.
Fanning Timing and Delays
Fanning timing and delays work exactly like fanning parameters.
• [1] [Thru] [5] [Time] [6] [Thru] [1] [0] [Enter] - sets the discrete times for channel 1 to 6
seconds, 2 to 7 seconds, 3 to 8 seconds, 4 to 9 seconds, and 5 to 10 seconds.
• [1] [Thru] [5] [Delay] [6] [Thru] [8] {Fan} {Mirror} [Enter] - sets the discrete delays of
channel 1 to 8 seconds, 2 to 7 seconds, 3 to 6 seconds, 4 to 7 seconds, and 5 to 8 seconds.