Rvi3 start up, Remote video interface (rvi), Front panel – ETC Ion User Manual

Page 389: Electrical specification, N o t e

Using the RPU and RVI

373

Front Panel

Step 1:

Press the soft power switch to activate the RVI 3 (check rear panel to ensure power

is connected and hard power switch is on).

Step 2:

Backlit indicators identify the operating status (client, offline, in sync) of the unit.

Step 3:

USB port is provided for easy show loading to or from a USB storage device.

Step 4:

20 buttons are configurable from the Eos Configuration Utility (ECU). They are set to
a default configuration. The label strips for these buttons are removable and
reversible. Any changes to the button configuration can be written on the opposite
side in pencil.

RVI3 Start Up

At startup, the RVI will open in the Ion application or the ECU, based on the setup option. The
default setting is to open in the ECU.

Remote Video Interface (RVI)

Electrical Specification

• Operating voltage 100-240 VAC, 50-60Hz (2 amps at 120 VAC).

• Ambient temperature and humidity 0 - 35° C, 95% non-condensing humidity, maximum.

• Storage temperature and humidity 0 - 35° C, 95% non-condensing humidity

• CE and ETL Compliant.

• Installation Category II, indoor use only.

• May operate up to 2000 meters altitude.

N o t e :

If the unit does not power up, check the hard power switch, on the rear panel, to

ensure it is switched on.

Live

Tab

Escape

Select

M901

M902

M903

M904

Blind

M905

M906

M907

M908

Primary

Master

Backup

Sync

Client

Offline

Backlit

indicators

Soft Power

Switch

Removable

label strip

USB

20 command

keypad buttons