SkyTrak 6036 Service Manual - Manual (Page 71)

Section 5 Wheel Assembly, Tires, and Axle
Model 6036/6036T S/N 9B0500 thru 14833 5-21
turn and align any hole in the nut with a
major spline on the spindle. Mark the end
of the aligned spline on the edge of the
spindle. Make sure the hub rotates freely.
(d) Install roll pin (19) on the back face of
planetary ring gear (17) and mark its
location on the front face of the gear.
(e) Install planetary ring gear, making sure
roll pin is locked into locknut hole. Align
mark on the edge of the spindle with the
mark on the front face of the planetary
ring gear.
(f) Install spacer (16), sun spur gear (15),
and retaining ring (14) on the axle shaft.
8. On an axle with service brakes:
(a) Using a suitable lifting device, install the
hub assembly onto the spindle.
(b) Install the planetary ring gear/piston/
retainer unit on the spindle assembly,
being sure oil passage hole in ring gear is
to the bottom of the axle at 6 o’clock.
(c) Gradually increase torque on retainer
screws (25, Fig. 5.8) using a crossing
pattern until 45 lb-ft (61 Nm) is achieved
on each screw.
(d) Install lining stop plates (14 and 17, Fig.
5.8 and Fig. 5.12) and discs (18).
9. Install the planetary gear assembly as de-
scribed in paragraph 5.2.2.
5.2.5 Steering Cylinder and Tie Rod
a. Removal
Refer to page 20 through 22 of Spicer ® Dana
Maintenance Manual for Axle Models PS/PR-7036
for removal instructions.
Fig. 5.12 Park Lock Removal
b. Cleaning and Drying
1. Clean all parts with approved petroleum based
cleaner.
2. Use clean lint free towels to dry components
after cleaning.
3. After drying, components should be lightly
coated with oil or rust preventive to protect
them from corrosion.
c. Inspection and Replacement
1. Be sure rod is straight and undamaged. If rod
is bent or damaged, install new rod.
2. Check condition of tube, attaching hardware
and hydraulic hoses. Repair or replace as
required.
d. Installation
Refer to page 24 of Spicer ® Dana Maintenance
Manual for Axle Models PS/PR-7036 for installa-
tion instructions.
5.2.6 Park Lock Unit
The park lock unit consists of the park lock and a
yoke shaft.
a. Removal
Refer to page 54 of Spicer ® Dana Maintenance
Manual for Axle Models PS/PR-7036 for removal
instructions.
b. Disassembly
Refer to page 55 of Spicer ® Dana Maintenance
Manual for Axle Models PS/PR-7036 for disas-
sembly instructions.
COVER PLATE HEX BOLTS
RETAINER RING
SOCKET HEAD
CAPSCREWS
PINION NUT
DUST SLINGER
YOKE SHAFT BRAKE MODULE WITH PRES-
SURE AND SPRING PLATES
WASHER
MA0281