SkyTrak 6036 Service Manual - Manual (Page 308)

Section 10. Electrical System
10-46 Model 6036/6036T S/N 9B0500 thru 14833
LIGHTS
3. Work the opening in the boot into the groove
of the plunger so the metal of the plunger
bears against the actuator plate, not the boot.
Proper installation of the boot protects the
sliding plunger from contamination.
4. Install jam nut (1) on capscrew (4) and actua-
tor plate (2) on capscrew.
5. Install jam nut (3) on capscrew and then install
capscrew in brake pedal.
6. Readjust brake pedal stop position as de-
scribed in paragraph 4.3.1.
7. With brake pedal in its normal adjusted
position the plunger must be depressed
approximately 0.12" (3 mm). Adjust the
plunger by loosening the switch jam nut and
adjust by turning the boot as required to obtain
this dimension.
8. Tighten the switch jam nut to maintain this
adjustment.
9. Reconnect negative (–) cable to the batteries.
3. Tag and disconnect the wires from the switch.
4. Remove the hex nut which secures the switch
to the right front console panel.
b. Disassembly
Do not disassemble the switch.
c. Cleaning and Drying
Without submerging the switch, clean the switch
with an approved solvent and dry with a clean lint-
free cloth.
d. Inspection and Replacement
1. Inspect the switch terminals for continuity in
the switch halfway out and fully out positions
and shorting in the switch in position.
2. Replace the switch if it fails the tests in step 1.
e. Installation
1. Connect the wires as they were tagged during
switch removal.
2. Position the switch from under the right front
console panel.
3. Install switch and hex nut.
4. Install lower console panel.
5. Connect negative (–) cable to the batteries.
6. Test switch in all three positions.
Fig. 10.37 Windshield Washer/Wiper Switch
10.10 WINDSHIELD
WASHER/WIPER
10.10.1 Windshield Washer/Wiper
Switch (Enclosed Cab Only)
The windshield washer/wiper switch, Fig. 10.37, is
supplied on a forklift with an enclosed cab. Turn
knob to left to operate wiper at low speed; to right
to operate wiper at high speed. Press and hold
knob to activate windshield washer The wind-
shield washer fluid tank is located at the right side
of the seat.
LIGHT SWITCH
WINDSHIELD
WASHER/WIPER
SWITCH
OH0044
OA0612
Fig. 10.36 Headlight and Work Light Switch
10.9.4 Headlight and Rear Work Light
Switch
The headlights and rear work light are controlled
by a three position push-pull switch, Fig. 10.36, on
the instrument panel. This switch also controls the
headlights, directional signal lights, tail lights and a
light in the fuel gauge.
• Switch In: Lights OFF
• Switch Halfway Out: Headlights, Tail
Lights and Panel Lights ON
• Switch Fully Out: Headlights, Tail Lights,
Panel Lights, Rear Work Lights and Boom
Work Light (if so equipped) ON
a. Removal
1. Disconnect negative (–) cable (2, Fig. 10.16)
from the batteries.
2. Prepare to remove the light switch by remov-
ing the lower panel which is located below the
steering wheel.
EMERGENCY BRAKE
P
P
ROOF
WASHER/WIPER
SWITCH