SkyTrak 6036 Service Manual - Manual (Page 105)

Section 8A Perkins Engine
Model 6036/6036T S/N 9B0500 thru 14833 8A-13
8A.11.2 Radiator Pressure Cap
The system is designed to use a radiator pressure
cap to prevent the boiling of the lubricant. For a
210 °F (99 °C) system use a 7 psi (48 kPa)
radiator cap. An incorrect or malfunctioning cap
can result in the loss of coolant and the engine
running hot.
Fig. 8A.24 Thermostat Housing for a Turbo Engine
WATER TEMPERATURE
SENSOR
THERMOSTAT
MA2000
Fig. 8A.23 Thermostat Housing for a Naturally
Aspirated Perkins Engine
THERMOSTAT
MA1990
WATER TEMPERATURE
SENSOR
8A.11.3 How to Replace Thermostat
and Water Temperature Sensor
If it becomes necessary to replace the thermostat
and/or water temperature sensor, Figs. 8A.23 and
24, proceed as follows.
1. Drain Coolant.
2. Disconnect hose.
3. Remove outlet adaptor.
4. Remove thermostat or sensor.
5. Clean the gasket area of the housing.
6. Position thermostat or thread sensor in
housing.
7. Place gasket and hose connection over
thermostat.
8. Install lock washer and capscrew.
9. Torque the capscrews to 18 lb-ft (24 Nm).
Fig. 8A.25 Oil Filter with Integral Oil Cooler
1. Filter Head
2. Connection
3. Gasket
4. Stud (2)
5. Nut (2)
6. Washer (2)
7. Connector
8. Oil Cooler
9. Seal
10. Oil Filter
11. Hose Clamp
12. Hose
4
3
1
6
5
7
2
9
12
11
8
10
MA0331
8A.11.4 Integral Oil Cooler in Oil Filter
The oil filter for a turbocharged engine, Fig. 8A.25,
has an integral oil cooler. Whenever you change
engine coolant, drain the oil cooler by removing
inlet and outlet connections, flush the cooler and
reconnect hoses.