Warning – SkyTrak 6036 Service Manual User Manual
Page 199
Section 9
Hydraulic System
Model 6036/6036T S/N 9B0500 thru 14833
9-49
Before starting the engine be sure all hydraulic
connections are tight and all tools are removed
from the forklift.
Warning
MA0541
Fig. 9.24 Slave Cylinder Exploded View
6.
Instruct the operator to extend or retract the
cylinder slowly until the rod end eye is aligned
with the outer boom mounting holes. Secure
the slave cylinder to the outer boom with its
locking capscrew and locknut.
7.
Tilt grille (forks) up fully, then down fully and
then approximately level. Raise the boom as
far as it will go; then lower it as far as it will go
five times while observing the grille. The grille
should hold in the same position during boom
raising and lowering in the last two cycles.
5.
Position the slave cylinder so that the rod is
aligned with the rod end mounting holes as
much as possible.
3
12
13
11
10
5
6
1
11
10
4
5
6
7
8
9
14
1
2
4
1.
Bushing (2)
2.
Cylinder Tube
3.
Locknut
4.
Gland
5.
Backup Ring
6.
O-ring
7.
O-ring
8.
Piston Seal
9.
Piston
10. Rod Seal
11. Wiper
12. Rod
13. Grease Fitting
14. Grease Fitting (90°)
KITS
Seal Kit, Slave Cylinder
(Includes Items 5, 6, 7, 8,
10, and 11)