14 troubleshooting contents – SkyTrak 6036 Service Manual User Manual
Page 318
![background image](/manuals/546105/318/background.png)
Section 10.
Electrical System
10-56
Model 6036/6036T S/N 9B0500 thru 14833
5.
Replace coolant in engine and heater lines,
connect the ground cable (2, Fig. 10.16) to the
negative terminals of the batteries, start the
engine, allow engine to idle for several min-
utes, and check for leakage at the heater
connections.
6.
Disconnect battery ground cable (2, Fig.
10.16) from the negative terminals of the
batteries.
7.
Connect wiring to motor.
8.
Prepare to electrically ground the heater unit
by positioning tooth type ground washers (3,
Fig 10.42) over the tapped holes in the coolant
inlet/outlet side of the heater. Use a thin,
transparent tape to temporarily secure the
washers to the heater unit.
9.
Slide heater and fan unit (7) into position
under suspension support (12) without disturb-
ing the ground washers (3) which were taped
into position during the previous step.
10. Install two lock washers (5), capscrews (4)
and spacers (6) at the other side of the
suspension support (12).
11. Install two lock washers (2) and capscrews (1)
through the holes in the suspension support
(12) and through the tooth type grounding
washers (3) into the tapped holes in the
heater.
12. Connect negative (–) cable (2, Fig. 10.16) to
the batteries.
13. Test heater fan motor operation.
10.14 TROUBLESHOOTING
CONTENTS
Title
Page
WARNING DEVICES
10-57
Horn, Backup Alarm, Reverse Switch and
Warning Lights
10-57
CIRCUIT BREAKERS/FUSES
10-58
STARTING SYSTEM
10-59
Starter, Starting Motor Relay and
Thermo Start Plug
10-59
CHARGING SYSTEM
10-62
Alternator and Batteries
10-62
SWITCHES AND SOLENOIDS
10-63
Ignition and Neutral Start Switches
10-63
Fuel Run Solenoid
10-64
Park Lock Switch
10-64
Reverse Switch and Backup Alarm
10-65
Steering Select Switch and Solenoid
10-65
GAUGES AND INDICATOR LIGHTS
10-65
Hourmeter
10-65
Warning Lights
10-66
Engine Low Oil Pressure Switch
10-66
Engine Coolant High Temperature Switch
10-67
Alternator Warning Light
10-67
Transmission High Oil Temperature Switch
10-67
Fuel Level Gauge
10-68
OPTIONAL LIGHT CIRCUIT
10-68
Directional and Emergency Flasher Switch
10-68
Momentary Brake Light and Switch
10-69
Headlight and Rear Work Light Switch
10-69
WINDSHIELD WASHER/WIPER
10-70
AIR CIRCULATION FAN
10-73
CAB HEATER
10-73