SkyTrak 6036 Service Manual - Manual (Page 306)

Section 10. Electrical System
10-44 Model 6036/6036T S/N 9B0500 thru 14833
a. How to Operate the Emergency Flashers
To operate the emergency flashers, pull flasher
tab out. All signal lamps and red pilot light will
flash. To cancel the emergency flashers, move
the directional signal lever momentarily in either
direction.
1. Screw (2)
2. Top cover
3. Directional signal switch
4. Spring clip and socket
5. Pilot bulb
6. Wiring harness
Fig. 10.33 Pilot Bulb Replacement
b. Flasher and Pilot Bulb Replacement
To replace the pilot bulb, remove two screws (1,
Fig. 10.33) and lift top cover (2) of directional
signal switch (3). When cover is removed, pull
spring clip (4) away from handle. Remove old pilot
bulb (5) and install a new No. 53 bulb for 12 volt
service. Engage the spring clip into the handle.
Do not try to test pilot bulb until switch is reas-
sembled and grounded.
Fig. 10.34 Directional and Emergency Flasher Switch Removal
1
2
3
4
5
6
MA1351
MA1362
GREEN PILOT LIGHTÐLEFT TURN
RED PILOT LIGHTÐEMERGENCY FLASHER
GREEN PILOT LIGHTÐRIGHT TURN
TO CHANGE PILOT BULB
REMOVE TWO SCREWS AND
TOP COVER, SEE FIGURE 10.56
DIRECTIONAL SIGNAL
SWITCH HANDLE
EMERGENCY
FLASHER TAB
SCREW
ANCHOR CLIP
STRAP
The flasher mount (12, Fig. 10.30 or 10, Fig.
10.30A) is located above and to the right of the
brake pedal. When replacing a flasher, use
Flasher No. 180 for this 12 V system.
c. Switch Removal
1. Remove console cover below steering wheel.
2. Disconnect negative cable (2, Fig. 10.16) from
the batteries.
3. Disconnect wiring.
4. Remove screws, anchors, clips, strap and
switch.
d. Switch Disassembly
There are no serviceable parts in the switch
except the bulbs.
e. Switch Inspection and Replacement
1. If the switch has been in service for a long
period of time, prepare to remove the top
cover of the switch by removing two screws.
2. Apply silicon lubricant to the switch lever pivot
and mechanical contact areas.
3. Replace top cover and two screws.
f. Switch Installation
1. Make sure you disconnect the ground cable
(2, Fig. 10.16) from the negative terminals of
the batteries and remove the flasher during
installation and wiring.
2. Refer to schematic Fig. 10.31 and reconnect
the wires.
3. Tape ends of unused wires to prevent shorts.
4. Mount switch on steering column as shown in
Fig. 10.34.
5. Insert screws into anchors.