beautypg.com

System:cconfig – Agilent Technologies Agilent E5250A User Manual

Page 211

background image

Agilent E5250A User’s Guide, Edition 11

7-43

Command Reference

:SYSTem:CCONfig?

:SYSTem:CCONfig?

This query command returns the card configuration information. This command has
query form only.

Syntax

:SYSTem:CCONfig? card_number

Query response

card_configuration <^END>

For the E5252A: no response. Always returns #10.

For the E5255A: definite length block response data, #16ABCDEF, where each
letter is 8-bit binary data as follows:

A: indicates input port (1 to 6) that is connected to block 1.

B: indicates if resistance is set for block 1 Bias Port: 1: resistance set, 0: not set

C: indicates input port (1 to 6) that is connected to block 2.

D: indicates if resistance is set for block 2 Bias Port: 1: resistance set, 0: not set

E: indicates input port (1 to 6) that is connected to block 3.

F: indicates if resistance is set for block 3 Bias Port: 1: resistance set, 0: not set

Example

OUTPUT @Hp5250;":SYST:CCON? 1"

ENTER @Hp5250;A$

ENTER A$ USING "3X,6A";B$

FOR I=1 TO 6

C=NUM(B$[I;1])

PRINT "BYTE No. ";I;"= ";C

NEXT I

Parameter Explanation

card_number

card number: 1, 2, 3, or 4