Allied Telesis AT-8550 - Manual (Page 47)

AT-9108, AT-8518, AT-8525, and AT-8550 User’s Guide
2-23
The command syntax to configure GMT offset and usage of
Daylight Savings is as follows:
config timezone {autodst |
noautodst}
The GMT_OFFSET is in +/- minutes from the GMT time.
Automatic Daylight Savings Time (DST) changes can be
enabled or disabled. The default setting is enabled.
3. Enable the SNTP client using the following command:
enable sntp-client
Once enabled, the switch sends out a periodic query to the
NTP servers defined later (if configured) or listens to broadcast
NTP updates from the network. The network time information
is automatically saved into the on-board real-time clock.
4. If you would like this switch to use a directed query to the NTP
server, configure the switch to use the NTP server(s). If the switch
listens to NTP broadcasts, skip this step. To configure the switch to
use a directed query, use the following command:
config sntp-client [primary | secondary]
server [ | ]
+8:00 +480 CCT - China Coast, Russia
Zone 7
+9:00 +540 JST - Japan Standard, Russia
Zone 8
+10:00 +600 EAST - East Australian
Standard
GST - Guam Standard
Russia Zone 9
+11:00 +660
+12:00 +720 IDLE - International Date Line
East
NZST - New Zealand Standard
NZT - New Zealand Wellington, New Zealand; Fiji,
Marshall Islands
Table 2-7 Greenwich Mean Time Offsets (Continued)
GMT
Offset in
Hours GMT
Offset in
Minutes
Common Time Zone
References
Cities