Allied Telesis AT-8550 - Manual (Page 219)

AT-9108, AT-8518, AT-8525, and AT-8550 User’s Guide
12-11
Access Policy Commands
Table 12-1 shows the commands used to configure access policy.
Table 12-1 Access Policy Configuration Commands
Command Description
create access-profile
type [vlan | ipaddress] Creates an access profile. Once the access profile is
created, one or more addresses can be added to it,
and the profile can be used to control a specific
routing protocol
config access-profile
mode [permit | deny] Configures the access profile to be one of the
following:
❑
permit — Allows the addresses that match
the access profile description.
❑
deny — Denies the addresses that match the
access profile description.
The default setting is permit .
config access-profile add
{vlan | ipaddress
Adds an IP address or VLAN name to the access
profile. The entry must be of the same type as the
access profile (for example, IP address).
config access-profile
delete {vlan | ipaddress
Deletes an IP address or VLAN name from the
access profile.
config rip vlan [ | all] trusted-
gateway [ | none] Configures RIP to use the access list to determine
which RIP neighbor to receive (or reject) the
routes.
config rip vlan [ | all] import-filter
[ | none] Configures RIP to ignore certain routes received
from its neighbor.
config rip vlan [ | all ] export-filter
[ | none] Configures RIP to suppress certain routes when
performing route advertisements.
config ospf area external-filter
[ | none] Configures the router to use the access policy to
determine which external routes are allowed to be
exported into the area. This router must be an ABR.
config ospf area interarea-filter
[ | none] Configures the router to use the access policy to
determine which inter-area routes are allowed to
be exported into the area. This router must be an
ABR.
config dvmrp vlan [ | all] export-
filter [ | none] Configures DVMRP to filter out certain routes
when performing the route advertisement.