Allied Telesis AT-8550 - Manual (Page 43)

AT-9108, AT-8518, AT-8525, and AT-8550 User’s Guide
2-19
IP Host Configuration Commands
Table 2-5 describes the commands that are used to configure IP
settings on the switch.
Table 2-5 IP Host Configuration Commands
Command Description
config iparp add
Adds a permanent entry to the Address Resolution
Protocol (ARP) table. Specify the IP address and
MAC address of the entry.
config iparp delete Deletes an entry from the ARP table. Specify the IP
address of the entry.
clear iparp { | vlan } Removes dynamic entries in the IP ARP table.
Permanent IP ARP entries are not affected.
config iproute add
{} Adds a static address to the routing table. Use a
value of 255.255.255.255 for
mask to indicate a host
entry.
config iproute delete
Deletes a static address from the routing table.
config iproute add default
{} Adds a default gateway to the routing table. A
default gateway must be located on a configured IP
interface. If no metric is specified, the default metric
of 1 is used.
config iproute delete default Deletes a default gateway from the routing table.
show ipconfig {vlan } Displays configuration information for one or all
VLANs.
show ipstats {vlan } Displays IP statistics for the CPU of the switch or for
a particular VLAN.
show iproute {priority | vlan |
permanent | } Displays the contents of the IP routing table.
show iparp { |
permanent} Displays the IP ARP table. You can filter the display
by IP address, VLAN, or permanent entries.