Allied Telesis AT-8550 - Manual (Page 202)

IPX Commands
11-10
Table 11-4 describes the commands used to configure the IPX route
table.
Table 11-4 IPX/RIP Configuration Commands
Command Description
enable ipxrip Enables IPX/RIP on the router.
config ipxrip add vlan [ | all} Configures one or all IPX VLANs to run IPX/RIP.
IPX/RIP is enabled by default when you configure
the IPX VLAN.
config ipxrip delete vlan [ | all] Disables IPX/RIP on one or all interfaces.
config ipxrip {vlan | all} max-
packet-size Configures the maximum transmission unit (MTU)
size of the IPX/RIP packet. the default setting is
432 bytes.
config ipxrip vlan [ | all] update-
interval {hold-multiplier
} Configures the update interval and hold multiplier
for IPX/RIP updates. This setting affects both the
periodic update interval of IPX/RIP and the aging
interval of learned routes. The default update
interval is 60 seconds. The aging period is
calculated using the formula (update-interval x
multiplier). The default multiplier is 3.
config ipxrip vlan [ | all] delay
Configures the time between each IPX/RIP packet
within an update interval. The default setting is 55
milliseconds.