Allied Telesis AT-8550 - Manual (Page 116)

Traffic Groupings and Creating a QoS Policy
7-10
Table 7-3 describes the options for the long form syntax.
Table 7-3 Config IPQoS Command Options
Command Option Description
[add | delete] Adds or deletes an IPQoS traffic grouping.
[tcp | udp | other | all] The protocol selection for the traffic grouping.
Specify one of the following:
❑
tcp — The TCP protocol is used for this traffic
grouping.
❑
udp — The User Datagram Protocol (UDP) is
used for this traffic grouping.
❑
other — An IP protocol other than TCP or
UDP is used for this traffic grouping.
❑
all — Any IP protocol is used for this traffic
grouping.
/ The destination IP address (or group of IP
addresses) to which the QoS profile is applied.
{l4-dstport } The layer 4 destination port number. This is the IP
port number associated with the protocol
specified in the command string. If TCP is used as
the protocol, the layer 4 port number is a TCP port
number. If UDP is used, the layer 4 port number is
a UDP port number. If not specified all port
numbers used by the IP protocol (TCP or UDP) are
implied.
{/} The source IP address (or group of IP addresses)
to which the QoS profile is applied.
{l4-srcport } The layer 4 source port number. This is the IP port
number associated with the protocol specified in
the command string. If TCP is used as the
protocol, the layer 4 port number is a TCP port. If
UDP is used, the layer 4 port number is a UDP
port.
[qosprofile | blackhole] The name of the QoS profile that is used by this
traffic grouping.