Allied Telesis AT-8550 - Manual (Page 171)

AT-9108, AT-8518, AT-8525, and AT-8550 User’s Guide
9-17
Resetting and Disabling RIP
To return RIP settings to their defaults, or to disable RIP, use the
commands listed in
Table 9-4 .
Table 9-4 RIP Reset and Disable Commands
Command Description
config rip delete [vlan | all] Disables RIP on an IP interface. When RIP is disabled on
the interface, the parameters are not reset to their
defaults.
disable rip Disables RIP.
disable rip aggregation Disables the RIP aggregation of subnet information on a
RIP v2 interface.
disable rip splithorizon Disables split horizon.
disable rip poisonreverse Disables poison reverse.
disable rip triggerupdate Disables triggered updates.
disable rip export static Disables the filtering of static routes.
disable rip export osfp Disables the distribution of OSPF routes into the RIP
domain.
unconfig rip {vlan } Resets all RIP parameters to match the default VLAN.
Does not change the enable/disable state of the RIP
settings. If no VLAN is specified, all VLANs are reset.