Allied Telesis AT-8550 - Manual (Page 230)

Logging
13-10
Logging
Commands
The commands described in Table 13-5 allow you to configure
logging options, reset logging options, display the log, and clear the
log.
Table 13-5 Logging Command
Command Description
enable log display Enables the log display.
enable syslog Enables logging to a remote syslog host.
config log display {} Configures the real-time log display. Options include:
❑
priority — Filters the log to display messages
with the selected priority or higher (more critical).
Priorities include critical, emergency, error, alert,
warning, notice, info, and debug. If not specified,
informational priority messages and higher are
displayed.
config syslog
{} Configures the syslog host address and filters
messages sent to the syslog host. Options include:
❑
ipaddress — The IP address of the syslog host.
❑ facility — The syslog facility level for local use
(local0 - local7).
❑
priority — Filters the log to display messages
with the selected priority or higher (more critical).
Priorities include critical, emergency, alert, error,
warning, notice, info, and debug. If not specified,
only critical priority messages and are sent to the
syslog host.
disable log display Disables the log display.
disable syslog Disables logging to a remote syslog host.
show log {} Displays the current snapshot of the log. Options
include:
❑
priority — Filters the log to display message
with the selected priority or higher (more critical).
Priorities include critical, emergency, alert, error,
warning, notice, info, and debug. If not specified,
informational priority messages and higher are
displayed.
show log config Displays the log configuration, including the syslog
host IP address, the priority level of messages being
logged locally, and the priority level of messages being
sent to the syslog host.
clear counters Clears all switch statistics and port counters.
clear log {static} Clears the log. If static is specified, the critical log
messages are also cleared.