Allied Telesis AT-8550 - Manual (Page 145)

AT-9108, AT-8518, AT-8525, and AT-8550 User’s Guide
8-17
IP Commands
Table 8-3 describes the commands used to configure basic IP
settings.
Table 8-3 Basic IP Commands
Command Description
enable bootp vlan [ | all] Enables the generation and processing of BootP
packets on a VLAN to obtain an IP address for the
VLAN from a BootP server. The default setting is
enabled for all VLANs.
enable bootprelay Enables the forwarding of BootP and Dynamic
Host Configuration Protocol (DHCP) requests.
enable ipforwarding {vlan } Enables IP routing for one or all VLANs. If no
argument is provided, enables routing for all
VLANs that have been configured with an IP
address. The default setting for
ipforwarding is
disabled.
enable ipforwarding broadcast {vlan
} Enables forwarding IP broadcast traffic for one or
all VLANs. If no argument is provided, enables
broadcast forwarding for all VLANs. To enable,
ipforwarding must be enabled on the VLAN.
The default setting is enabled.
enable multinetting Enables IP multinetting on the system.
config bootprelay add Adds the IP destination address to forward BootP
packets.
config bootprelay delete [ |
all] Removes one or all IP destination addresses for
forwarding BootP packets.
config iparp add
Adds a permanent entry to the ARP table. Specify
the IP address and MAC address of the entry.
config iparp delete Deletes an entry from the ARP table. Specify the IP
address of the entry.
disable bootp vlan [ | all] Disables the generation and processing of BootP
packets.