Allied Telesis AT-8550 - Manual (Page 111)

AT-9108, AT-8518, AT-8525, and AT-8550 User’s Guide
7-5
Modifying a QoS
Profile
You can modify the default profiles as desired. To modify the
parameters of an existing QoS profile, use the following command:
config qosprofile {minbw }
{maxbw } {priority }
Creating and
Deleting a QoS
Profile
In egress mode, up to 28 additional custom QoS profiles can be
created on the switch. Because ingress mode (the default) uses the
four pre-defined QoS profiles, you cannot create custom QoS profiles
when using ingress mode.
To create a QoS profile in egress mode, use the following command:
create qosprofile
A new QoS profile is created with the following default values:
❑ Minimum bandwidth — 0%
❑ Maximum bandwidth — 100%
❑ Priority — low
These parameters can then be modified, as described previously.
To delete a QoS profile created in egress mode, use the following
command:
delete qosprofile
When a QoS profile is removed, all entries previously associated with
the QoS profile are changed to use the settings of the default QoS
profile named qp1.