Allied Telesis AT-8550 - Manual (Page 203)

AT-9108, AT-8518, AT-8525, and AT-8550 User’s Guide
11-11
Table 11-5 describes the commands used to configure IPX/SAP.
Table 11-5 IPX/SAP Configuration Commands
Command Description
enable ipxsap Enables IPX/SAP on the router.
enable ipxsap gns-reply {vlan } Enables GNS reply on one or all IPX interfaces. If
no VLAN is specified, GNS reply is enabled on all
IPX interfaces. The default setting is enabled.
config ipxsap vlan gns-delay
Configures the amount of time the switch waits
before answering a GNS request. By default, the
switch answers a GNS request as soon as possible
(0 milliseconds).
config ipxsap add vlan [ | all] Configures an IPX VLAN to run IPX/SAP routing. If
no VLAN is specified, all VLANs are configured to
run IPX/SAP routing. IPX/SAP routing is enabled
by default when the IPX VLAN is configured.
config ipxsap delete vlan [ | all] Disables IPX/SAP on an interface.
config ipxsap vlan [ | all] max-
packet-size Configures the MTU size of the IPX/SAp packets.
The default setting is 432 bytes.
config ipxsap vlan [ | all] update-
interval {hold-multiplier
} Configures the update interval and hold
multiplier for IPX/SAP updates. This setting
affects both the periodic update interval of SAP
and the aging interval of learned routes. The
default update interval is 60 seconds. The aging
period is calculated using the formula (update-
interval x multiplier). The default multiplier is 3.
Triggered update is always enabled; therefore,
new information is processed and propagated
immediately.
config ipxsap vlan [ | all] delay
Configures the time between each SAP packet
within an update interval. The default setting is
55 milliseconds.