Allied Telesis AT-8550 - Manual (Page 124)

Traffic Groupings and Creating a QoS Policy
7-18
Physical and
Logical
Groupings
Two traffic groupings exist in this category:
❑ Source port
❑ VLAN
Source Port. A source port traffic grouping implies that any traffic
sourced from this physical port uses the indicated QoS profile when
the traffic is transmitted out any other port. To configure a source
port traffic grouping, use the following command:
config ports qosprofile
VLAN. A VLAN traffic grouping indicates that all intra-VLAN
switched traffic and all routed traffic sourced from the named VLAN
uses the indicated QoS profile. To configure a VLAN traffic grouping,
use the following command:
config vlan qosprofile
For example, all devices on VLAN servnet require use of QoS profile
qp4 for both traffic between devices on follows, as well as traffic
sourced on servnet that is routed to other VLANs within the switch.
The command to configure this example is as follows:
config vlan servnet qosprofile qp4
Verifying Physical and Logical Groupings. To verify settings on
port or VLANs, use the command
show qosprofile
The same information is also available using the command
show ports info
for ports and
show vlan
for VLANs