Allied Telesis AT-8550 - Manual (Page 186)

Configuring IP Multicasting Routing
10-6
config dvmrp timer
Configures the global DVMRP timers. Specify the
following:
❑
route_report_interval — The amount
of time the system waits between transmitting
periodic route report packets. The range is 1 to
2,147,483,647 seconds (68 years). The default
setting is 60 seconds. Because triggered update
is always enabled, the route report will always
be transmitted prior to the expiration of the
route report interval.
❑
route_replacement_time — The hold-
down time before a new route is learned, once
the previous route has been deleted. The range
is 1 to 2,147,483,647 seconds (68 years). The
default setting is 140 seconds.
config pim-dm add vlan [ | all] Enables PIM-DM on an IP interface. When an IP
interface is created, per-interface PIM-DM
configuration is disabled by default.
config pim-dm delete vlan [ | all] Disables PIM-DM on an interface.
config pim-dm timer Configures the global PIM-DM timers. Specify the
following:
❑
hello_interval — The amount of time
before a hello message is sent out by the PIM-
DM router. The range is 1 to 65,519 seconds.
The default setting is 30 seconds.
Table 10-1 IP Multicast Routing Configuration Commands (Continued)
Command Description