Allied Telesis AT-8550 - Manual (Page 173)

AT-9108, AT-8518, AT-8525, and AT-8550 User’s Guide
9-19
config ospf [area | vlan [ |
all]] priority Configures the priority used in the designated
router-election algorithm for one or all IP
interface(s) of for all the interfaces within the
area. The range is 0 through 255, and the default
setting is 1. Setting the value to 0 ensures that
the router is never selected as the designated
router or backup designated router.
config ospf add vlan [ | all] Enables OSPF on one or all VLANs (router
interfaces). The default setting is disabled.
config ospf delete vlan [ | all] Disables OSPF on one or all VLANs (router
interfaces).
config ospf add virtual-link
Adds a virtual link connected to another ABR.
Specify the following:
❑
routerid — Far-end router interface
number.
❑
areaid — Transit area used for connecting
the two end-points. The transit area cannot
have the IP address 0.0.0.0.
config ospf delete virtual-link
Removes a virtual link.
config ospf area normal Configures an OSFP area as a normal area. The
default setting is
normal .
config ospf area stub [summary |
nosummary] stub-default-cost Configures an OSPF area as a stub area.
config ospf area nssa [summary |
nosummary] stub-default-cost
{translate} Configures an OSPF area as a NSSA.
config ospf area add range
[advertise |
noadvertise] {type 3 | type 7} Configures a range of IP addresses in an OSPF
area. If advertised, the range is exported as a
single LSA by the ABR.
config ospf area delete range
Deletes a range of IP addresses in an OSPF area.
config ospf routerid [automatic | ] Configures the OSPF router ID. If automatic is
specified, the switch uses the largest IP interface
address as the OSPF router ID. The default
setting is
automatic .
Table 9-5 OSPF Configuration Commands (Continued)
Command Description