Allied Telesis AT-8550 - Manual (Page 147)

AT-9108, AT-8518, AT-8525, and AT-8550 User’s Guide
8-19
Table 8-4 describes the commands used to configure the IP route
table.
Table 8-4 Route Table Configuration Commands
Command Description
enable iproute sharing Enables load sharing if multiple routes to the same
destination are available. Only paths with the same
lowest cost are shared. The default setting is
enabled.
config ipqos add
qosprofile Adds a QoS profile to an IP destination address.
config ipqos delete
Deletes a QoS profile from an IP destination address.
config iproute add
Adds a static address to the routing table. Use a
value of 255.255.255.255 for
mask to indicate a host
entry
config iproute delete
Deletes a static address from the routing table.
config iproute add blackhole
Adds a blackhole address to the routing table. All
traffic destined for the configured IP address is
dropped, and no Internet Control Message Protocol
(ICMP) message is generated.
config iproute delete blackhole
Deletes a blackhole address from the routing
table.
config iproute add default
{} Adds a default gateway to the routing table. A
default gateway must be located on a configured IP
interface. If no metric is specified, the default metric
of 1 is used.
config iproute delete default Deletes a default gateway from the routing table.
config iproute priority [rip | bootp | icmp |
static | ospf-intra | ospf-inter | ospf-as-
external | ospf-extern1 | ospf-extern2 ]
Changes the priority for all routes from a particular
route origin.
disable iproute sharing Disables load sharing for multiple routes.