Allied Telesis AT-8550 - Manual (Page 167)

AT-9108, AT-8518, AT-8525, and AT-8550 User’s Guide
9-13
config rip add vlan [ | all] Configures RIP on an IP interface. If no VLAN is
specified, then
all is assumed. When an IP
interface is created, per-interface RIP
configuration is disabled by default.
config rip delete vlan [ | all] Disables RIP on an IP interface. When RIP is
disabled on the interface, the parameters are
not reset to their defaults.
config rip garbagetime {} Configures the RIP garbage time. The timer
granularity is 10 seconds. The default setting is
120 seconds.
config rip routetimeout {} Configures the route timeout. The timer
granularity is 10 seconds. The default setting is
180 seconds.
config rip rxmode [none | v1only | v2only |
any] {vlan } Changes the RIP receive mode for one or all
VLANs. Specify:
❑
none — Drop all received RIP packets.
❑
v1only — Accept only RIP v1 format
packets.
❑
v2only — Accept only RIP v2 format
packets.
❑
any — Accept both RIP v1 and v2 packets.
If no VLAN is specified, the setting is applied to
all VLANs. The default setting is
any .
config rip txmode [none | v1only | v1comp |
v2only] {vlan } Changes the RIP transmission mode for one or
all VLANs. Specify:
❑
none — Do not transmit any packets on this
interface.
❑ v1only — Transmit RIP v1 format packets
to the broadcast address.
❑
v1comp — Transmit RIP v2 format packets
to the broadcast address.
❑
v2only — Transmit RIP v2 format packets
to the RIP multicast address.
If no VLAN is specified, the setting is applied to
all VLANs. The default setting is
v2only .
config rip updatetime {} Changes the periodic RIP update timer. The
timer granularity is 10 seconds. The default
setting is 30 seconds.
Table 9-2 RIP Configuration Commands (Continued)
Command Description