Allied Telesis AT-S70 - Manual (Page 80)

Chapter 7: Working with Line Cards and Other Modules
80
4. Select Port A (fiber - top) or Port B (copper - bottom) of the line card.
5. Press .
The Port Management Menu, shown in Figure 33, is displayed.
Figure 33. Port Management Menu
6. From the Port Management Menu, select Port Configurations.
The Port Configuration Menu, shown in Figure 34, is displayed.
Figure 34. Port Configuration Menu
7. From the Port Configuration Menu, select Port Enable to enable the
port or Port Disable to disable the port. The default is enabled.
Once the port is disabled, it no longer receives or sends packets. You
might want to disable a port if a problem occurs with the end-node or
with the cable connected to the port. Once the problem is fixed, you
can enable the port again to resume normal operation. You can also
disable an unused port to secure it from unauthorized connections.
8. Press or select the “Return to ...” option at the bottom of the
menu, to save the settings and return to the previous menu.
Port Management Menu
Module 4 - Port A
Port Configurations
OAM Configurations
Return to Module Configuration Menu...
Port Configuration Menu
Converteon
Module 4 - Port A
> Port Enable
Port Disable
> Auto negotiate
Full
Half
Ingress_Rate_Limit
Egress_Rate_Limit
Return to Module Management Menu...