Allied Telesis AT-S70 - Manual (Page 43)

AT-S70 Management Software User’s Guide
43
Pinging a Remote System
You can instruct the chassis to ping a remote device on your network. This
procedure is useful in determining whether a valid link exists between the
chassis and another device. The chassis sends an Internet Control
Message Protocol (ICMP) echo request to the end node. If the end node is
operating and receives the request, it sends a reply to the chassis.
To instruct the chassis to ping a network device, perform the following
procedure:
1. From the Main Menu, select Administration.
The Administration Menu, shown in Figure 8, is displayed.
Figure 8. Administration Menu
2. From the Administration Menu, select Ping a remote system.
Administration Menu
Converteon
Image Download Through TFTP
Image Download Through XMODEM
LineCard Image Download Through XMODEM
LineCard Image Download Through TFTP
Upload Configuration Through TFTP
Download Configuration Through TFTP
Ping a remote system
Syslog Server Address: Null (not configured)
Syslog Facility Code: 1
Event Log
Activity Monitor
> Start Log
Stop Log
Diagnostics
CPM Switch Over
Reset Chassis and Restart Line Cards
Return to Main Menu...